You Are Here: Home > Courses > Aerial Work Platform
*** COURSE LOCATION AND ADDRESS WILL BE IN THE CONFIRMATION EMAIL. CHECK YOUR EMAIL IF YOU REGISTER FOR A COURSE. IF YOU DO NOT RECEIVE A CONFIRMATION EMAIL WITHIN 48HRS OF REGISTRATION, CALL THE TRAINING CENTRE TO CONFIRM LOCATION. SHOWING UP AT THE WRONG LOCATION WILL RESULT IN A $150 NO SHOW FEE. ***
PLEASE READ YOUR CONFIRMATION EMAIL FOR THE LOCATION AND ADDRESS OF YOUR COURSE.
ACTC Course Location ID:
EAWP - Alberta Carpenters Training Centre (Edmonton) 176, 15210-123 Avenue NW
CAWP - Alberta Carpenters Training Centre (Calgary) 10, 1305-33 Street NE
Approved Safety Training Provider, ACTI, Course Location ID:
ECWAWP - ACTI’s New Office (Centre West, Edmonton) 12118 154 Street NW
EEIAWP - Electrical Industry Training Centre (Edmonton) 4234-93 Street
CANCELLATION POLICY:
Once you receive a confirmation email from the ACTC, you are considered registered. To cancel you must call or leave a message 48 hours in advance at (780) 455-6532 Ext. 4242 or by replying to your confirmation email to avoid a NO SHOW FEE of $150.00.
Please arrive between 7:30 a.m. and 7:45 a.m. for sign-in.
Class starts at 7:45 a.m. SHARP
Member Registration Fee is $25.00
Class Requirements:
Valid Fall Protection Ticket
Photo ID
$25.00 Registration Fee - DUE MORNING OF THE COURSE
Required Attire:
Substantial footwear (no Sandals or Flip Flops allowed)
No Dresses or Skirts (Participants are required to operate the equipment)
*********************************************************************
This training course is one-day and is an end user course complying with CSA standards. The course consists of 4 hours of classroom instruction and 4 hours of training in our simulators. During this course we will use a JLG 450 AJ for the practical’s being done in the field. This will be combined with Virtual Reality Training Simulation on our VR JLG 450 AJ. Competency assessments can be completed by us in a zero-harm environment and can be recorded during the simulations for employers’ proof of competency as requested. This simulator can be used for clients with no experience to very little experience on this type of equipment. This can be done in a risk-free environment, where making mistake is ok, and it will not result in an injury or loss of life due to training. (Course description taken off of ACTI website).
While this basic course can be used as part of a worker's competency assessment, the employer must designate a worker as a "competent person" based on specific tasks assigned.