You Are Here: Home > Courses > Basic Rigging (for members with NO RIGGING EXPERIENCE)
*** COURSE LOCATION AND ADDRESS WILL BE IN THE CONFIRMATION EMAIL. CHECK YOUR EMAIL IF YOU REGISTER FOR A COURSE. IF YOU DO NOT RECEIVE A CONFIRMATION EMAIL WITHIN 48HRS OF REGISTRATION, CALL THE TRAINING CENTRE TO CONFIRM LOCATION. SHOWING UP AT THE WRONG LOCATION WILL RESULT IN A NO SHOW FEE. ***
PLEASE READ YOUR CONFIRMATION EMAIL FOR THE LOCATION AND ADDRESS OF YOUR COURSE.
ACTC Course Location ID:
EBR - Alberta Carpenters Training Centre (Edmonton) 176, 15210-123 Avenue NW
CBR - Alberta Carpenters Training Centre (Calgary) 10, 1305-33 Street NE
Approved Safety Training Provider, ACTI, Course Location ID:
ECWBR - ACTI’s New Office (Centre West, Edmonton) 12118 154 Street NW
EEIBR - Electrical Industry Training Centre (Edmonton) 4234-93 Street
CANCELLATION POLICY:
Once you receive a confirmation email from the ACTC, you are considered registered. To cancel you must call or leave a message 48 hours in advance at (780) 455-6532 ext. 4242 or by replying to your confirmation email to avoid a NO SHOW FEE of $150.00.
Please arrive between 7:30 a.m. and 7:45 a.m. for sign-in.
Class starts at 7:45 a.m. SHARP
Member Registration Fee Is $25.00
Class Requirements:
Photo ID
$25.00 Registration Fee - DUE MORNING OF THE COURSE
Required Attire:
CSA Steel Toed Boots
Gloves
No Dresses Or Skirts (Must Operate Equipment)
*********************************************************************
· Rigging hardware inspection, sling capacity and demonstrating hand signals
Topics Covered:
· Legislation & Standards
· Load weight and calculations
· Sling angle stresses
· Centre of gravity
· Sling hitches and types
· Below the hook lifting devices
· Crane communication
While this basic course can be used as part of a worker's competency assessment, the employer must designate a worker as a "competent person" based on specific tasks assigned.